基于微波辐射研究城市污水污泥脱水特性

选用沈阳市仙女河污水处理厂和北部污水处理厂污水污泥作为微波脱水试验物料,分析物料性质、辐射强度、辐射时间以及添加剂投入量等对污泥脱水率和有机质损失率的影响. 结果表明:污泥中水分含量高的脱水效果最好,经过微波处理后的污泥有机质含量仍较高;辐射时间是最主要的影响因素,在540 W下辐射2～5 min即可达到良好效果;在合适的辐射时间下540～900 W都能达到良好的脱水效果,但在900 W时有机质的损失率较大,达到65.64%;添加剂投入量对污泥脱水基本不起作用,但可改变污泥微波干燥后的性状. 同时,运用灰色关联分析得到决定微波试验运行系统的主次因素,最后建立了影响因素对污泥脱水率和有机质损失率的经验公式.      

轻质陶粒滤料生态滤床的挂膜与启动研究

以自行设计的反应器作为生态滤床的基础,采用活性污泥作为接种污泥,采用轻质陶粒作为生态滤床的滤料,对其进行挂膜.在整个挂膜过程中,温度控制在中温条件下,进水pH值控制在7左右,水力停留时间为24 h,进水方式为连续进水,并根据需要对曝气量进行调节.在挂膜过程中对进、出水的COD、NH_3-N、TP、Cl~-和pH进行检测,并刮取少量轻质陶粒上的生物膜制成镜检切片后用多媒体显微镜对生物膜的形态进行观察.研究结果表明,在中温条件下采用活性污泥作为接种污泥,以轻质陶粒为滤料的生态滤床在15 d内挂膜成功;且随着进水污染负荷的提高,其去除率也逐渐提高,其中COD的去除率最后稳定在95%左右,NH3-N的去除率稳定在85%左右,TP的去除率在挂膜后期达到了80%以上;Cl~-作为微生物所需的微量元素在微生物生长高峰期为50%,稳定期保持在20%左右;进水pH保持在7左右,出水pH略高于进水,在8左右;从第13 d和第15 d的切片可观察到轮虫这种象征生物膜成熟的微生物的出现,此外还有大量的丝状菌和菌胶团.     

从造纸污泥中提取木质素制备缓蚀阻垢剂

以造纸污泥为原料,用碱溶酸析法提取其中的木质素,对木质素进行磺化改性后,与有机磷、锌盐等进行复配,以提高缓蚀阻垢效果。探讨了主原料配比、药剂投加量、反应温度、反应时间等对药剂性能的影响。结果表明:由该法制备的缓蚀阻垢剂性能较好,为造纸污泥的综合利用提供了一条新途径。     

水解酸化工艺的改进

综合水解酸化工艺传统的"膜法"和"泥法"两种工艺的优点,开发一种新的水解酸化工艺。把新工艺和传统的"膜法"工艺并联运行,进行对比实验,发现新工艺在有机物和色度的去除以及提高废水的可生化性方面均具有优势,COD去除率20%~30%,色度去除率60%,出水ρ(BOD5)/ρ(COD)在0.7左右。     

脱水污泥薄层干燥特性及动力学模型分析

采用薄层干燥方式进行脱水污泥热干燥的研究,考察了污泥的干燥特性,并引入薄层干燥模型进行数值分析.结果表明, Logarithmic模型比其他模型更适合薄层污泥干燥分析.应用Fick扩散模型,得到80~150℃条件下薄层污泥干燥的有效扩散系数的变化范围为8.486′10-10~4.386′10-9m2/s,并根据Arrhenius经验公式建立温度与扩散系数的关系,得到污泥干燥时水分扩散的活化能为29.56kJ/mol.     

Use of thermal analysis techniques (TG-DSC) for the characterization of diverse organic municipal waste streams to predict biological stability prior to land application

The use of organic municipal wastes as soil amendments is an increasing practice that can divert significant amounts of waste from landfill, and provides a potential source of nutrients and organic matter to ameliorate degraded soils. Due to the high heterogeneity of organic municipal waste streams, it is difficult to rapidly and cost-effectively establish their suitability as soil amendments using a single method. Thermal analysis has been proposed as an evolving technique to assess the stability and composition of the organic matter present in these wastes. In this study, three different organic municipal waste streams (i.e., a municipal waste compost (MC), a composted sewage sludge (CS) and a thermally dried sewage sludge (TS)) were characterized using conventional and thermal methods. The conventional methods used to test organic matter stability included laboratory incubation with measurement of respired C, and spectroscopic methods to characterize chemical composition. Carbon mineralization was measured during a 90-day incubation, and samples before and after incubation were analyzed by chemical (elemental analysis) and spectroscopic (infrared and nuclear magnetic resonance) methods. Results were compared with those obtained by thermogravimetry (TG) and differential scanning calorimetry (DSC) techniques. Total amounts of CO₂ respired indicated that the organic matter in the TS was the least stable, while that in the CS was the most stable. This was confirmed by changes detected with the spectroscopic methods in the composition of the organic wastes due to C mineralization. Differences were especially pronounced for TS, which showed a remarkable loss of aliphatic and proteinaceous compounds during the incubation process. TG, and especially DSC analysis, clearly reflected these differences between the three organic wastes before and after the incubation. Furthermore, the calculated energy density, which represents the energy available per unit of organic matter, showed a strong correlation with cumulative respiration. Results obtained support the hypothesis of a potential link between the thermal and biological stability of the studied organic materials, and consequently the ability of thermal analysis to characterize the maturity of municipal organic wastes and composts.     

Characterization and control of odorous gases at a landfill site: a case study in Hangzhou, China

Municipal solid waste (MSW) landfills are one of the major sources of offensive odors potentially creating annoyance in adjacent communities. At the end of May 2007, an odor pollution incident occurred at the Tianziling landfill site, Hangzhou, China, where the residents lodged complaints about the intense odor from the landfill, which drew a significant attention from the government. In this study, ambient air monitoring was conducted at the Tianziling landfill site. The main odor composition of the gas samples collected on June 1st 2007 and the reduction of various odorous gases from the samples collected on June 1st 2009 due to the applied odor control techniques were determined using gas chromatography-mass spectrometry (GC-MS). In addition, variations of primary odorous gaseous (NH₃ and H₂S) concentrations at different locations in the landfill site from July 2007 to June 2009 were also investigated by using classical spectrophotometric methods. Results showed that a total of 68 volatile compounds were identified among which H₂S (56.58-579.84 μg/m³) and NH₃ (520-4460 μg/m³) were the notable odor components contributing to 4.47-10.92% and 83.91-93.94% of total concentrations, respectively. Similar spatial and temporal shifts of H₂S and NH₃ concentrations were observed and were significantly affected by environmental factors including temperature, air pressure and wind direction. Odor pollution was worse when high temperature, high humidity, low air pressure, and southeast, northeast or east wind appeared. Moreover, the environmental sampling points of the dumping area and the leachate treatment plant were found to be the main odor sources at the Tianziling landfill site. The odor control technologies used in this project had a good mitigating effect on the primary odorous compounds. This study provides long-term valuable information concerning the characteristics and control of odors at landfill sites in a long run.     

Recovery of solid fuel from municipal solid waste by hydrothermal treatment using subcritical water

Hydrothermal treatments using subcritical water (HTSW) such as that at 234 °C and 3 MPa (LT condition) and 295 °C and 8 MPa (HT condition) were investigated to recover solid fuel from municipal solid waste (MSW). Printing paper, dog food (DF), wooden chopsticks, and mixed plastic film and sheets of polyethylene, polypropylene, and polystyrene were prepared as model MSW components, in which polyvinylchloride (PVC) powder and sodium chloride were used to simulate Cl sources.While more than 75% of carbon in paper, DF, and wood was recovered as char under both LT and HT conditions, plastics did not degrade under either LT or HT conditions. The heating value (HV) of obtained char was 13,886-27,544 kJ/kg and was comparable to that of brown coal and lignite. Higher formation of fixed carbon and greater oxygen dissociation during HTSW were thought to improve the HV of char.Cl atoms added as PVC powder and sodium chloride to raw material remained in char after HTSW. However, most Cl originating from PVC was found to converse into soluble Cl compounds during HTSW under the HT condition and could be removed by washing.From these results, the merit of HTSW as a method of recovering solid fuel from MSW is considered to produce char with minimal carbon loss without a drying process prior to HTSW. In addition, Cl originating from PVC decomposes into soluble Cl compound under the HT condition. The combination of HTSW under the HT condition and char washing might improve the quality of char as alternative fuel.     

Techno-economic evaluation of ultrasound and thermal pretreatments for enhanced anaerobic digestion of municipal waste activated sludge

To enhance the anaerobic digestion of municipal waste-activated sludge (WAS), ultrasound, thermal, and ultrasound + thermal (combined) pretreatments were conducted using three ultrasound specific energy inputs (1000, 5000, and 10,000 kJ/kg TSS) and three thermal pretreatment temperatures (50, 70 and 90 °C). Prior to anaerobic digestion, combined pretreatments significantly improved volatile suspended solid (VSS) reduction by 29-38%. The largest increase in methane production (30%) was observed after 30 min of 90 °C pretreatment followed by 10,000 kJ/kg TSS ultrasound pretreatment. Combined pretreatments improved the dimethyl sulfide (DMS) removal efficiency by 42-72% but did not show any further improvement in hydrogen sulfide (H₂S) removal when compared with ultrasound and thermal pretreatments alone. Economic analysis showed that combined pretreatments with 1000 kJ/kg TSS specific energy and differing thermal pretreatments (50-90 °C) can reduce operating costs by $44-66/ton dry solid when compared to conventional anaerobic digestion without pretreatments.     

Comparing the greenhouse gas emissions from three alternative waste combustion concepts

Three alternative condensing mode power and combined heat and power (CHP) waste-to-energy concepts were compared in terms of their impacts on the greenhouse gas (GHG) emissions from a heat and power generation system. The concepts included (i) grate, (ii) bubbling fluidised bed (BFB) and (iii) circulating fluidised bed (CFB) combustion of waste. The BFB and CFB take advantage of advanced combustion technology which enabled them to reach electric efficiency up to 35% and 41% in condensing mode, respectively, whereas 28% (based on the lower heating value) was applied for the grate fired unit. A simple energy system model was applied in calculating the GHG emissions in different scenarios where coal or natural gas was substituted in power generation and mix of fuel oil and natural gas in heat generation by waste combustion. Landfilling and waste transportation were not considered in the model. GHG emissions were reduced significantly in all of the considered scenarios where the waste combustion concepts substituted coal based power generation. With the exception of condensing mode grate incinerator the different waste combustion scenarios resulted approximately in 1 Mton of fossil CO₂-eq. emission reduction per 1 Mton of municipal solid waste (MSW) incinerated. When natural gas based power generation was substituted by electricity from the waste combustion significant GHG emission reductions were not achieved.